DivisionMaster back in stock!

We now have a few DivisionMaster kits in stock, and are busy assembling a few more finished units. We took the opportunity to make a couple of modifications to the board, which will include a little more space around the wire connections to allow easier fitting of spade terminals, and a two pin connector to supply power to the Fan. This will make removing the PCB easier in future should it need repairing, and will also reduce the number of times the PCB has to be taken out because I forgot to solder the fan wires on. Fans will now be supplied with a two pin molex socker already assembled to them. The wires for the motor and power connectors are supplied unassembled, but an assembled set with the terminals already crimped can be supplied on request.

We are looking into providing a backlight display as an option. There is enough power available from the regulator, an a dropper resistor will fit into the spare hole next to the 100u capacitor, so no major modifications are required, other than reducing the height of the pillars by 5mm or so.