Lester's New Blog

Lost work yet again without any obvious reason!

Where to spend time this year

Engineer rolled up with a pile of boxes and having confirmed that the problem was with the upper scanner proceeded to swap the top section of the printer with a new one. Half an hour later all is sorted and we are getting clean scans again. Now to get stuck into the last couple of hundred Model Engineer magazines now that I only need to run them through once.

Have been looking online to see what other volumes of the magazine are available pre-1950 and there have been a few batches t…

Still waiting for Brother

Having identified that there is a fault on the scanner of the printer getting it repaired is being painful